Notalentbum
Expert
I know these are showing some pressure signs. The extrusion around the pin divot and some marking on the heel from the bolt face. Can any experienced eyes tell a "degree" of over pressure? These were loaded to a couple recipes I found on the net. They were supposed to approximate 168gr FGMM. One was 42gr Benchmark which is the max recommended load and the other was 42.8gr of 4064 which is well under max.
Can having shot several of these cause damage to my rifle that's not obvious/visible?
I noticed that these are really tough to resize, taking a lot more pressure than normal on the handle to cycle through.
Matt
One of these days I'll figure out how to post pictures so they show directly in the post!
Can having shot several of these cause damage to my rifle that's not obvious/visible?
I noticed that these are really tough to resize, taking a lot more pressure than normal on the handle to cycle through.
Matt
One of these days I'll figure out how to post pictures so they show directly in the post!