2 ideas for Glock 19

[bonkers1919]

I recently saw a picture of a 1911 ( on INGO ) with the company's logos, model number removed from the slide. The look is nice and clean. The serations were left alone.


I want this look on one of the Glocks I have. How does one mill, grind or sand all those tattoos off? Is using a machinist, a VERY good machinist the way to go?

Any other ideas on how to achieve this look?

After it is done I would then Cerakote the gun.

 

[romad7]

Were the markings removed or was the slide made blank? If you remove the markings on the side of a Glock then you'll have a recessed area.

 

[BiscuitNaBasket]

This sounds like something in AllenM's territory.

 

[stephen87]

I'm willing to bet it was a Caspian slide. Those typically don't have rollmarks, if I remember correctly.

 

[The Bubba Effect]

Can the etchings be filled in with something, sanded flat and then the whole thing cerakoted?

 

[88E30M50]

JBWeld would work well for that.

 

[Double T]

Or you could order a lone wolf slide and leave the stock glock one alone.

 

[jfed85]

I remember seeing the thread, Im 99.9 positive that it was a Ruger SR1911 that it was done to.

 

[bonkers1919]

Like this on page 333 and 334 of 1911 show and tell.