APOD Firearms

Recent content by Iroquois

The #1 community for Gun Owners in Indiana

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!

    • Register Log in
    1. I

      Rolling block.

      Ok. Thanks for that. It was a legitimate question, and that was an honest answer.
    2. I

      125 grain plated .38 Special

      I have loaded green dot in small handgun rounds for years, mostly 38s... Very light light recoil, and they're accurate enough to hit my 11x14 ringers at 100 yards. As long as they function the gun, I'll probably use them in the 9mm. I will be test firing those before I go berserk on the...
    3. I

      125 grain plated .38 Special

      115 g powder coated and sized. I did find a load... Thanks for all the help everyone.
    4. I

      What have you done this week to prep? PART II

      In the process turning 80 pounds of bullets into reloads... .45s , .44 s .357s... .38s... Almost done...
    5. I

      125 grain plated .38 Special

      I'm loading Unique in the.38s . I've loaded green dot in 38s , easy on the wrist,but I'm looking for a little more umph.. I'm thinking that the green dot will be a better fit in the 9mm. Any experience with that?
    6. I

      125 grain plated .38 Special

      Ok... That makes more sense ‍
    7. I

      125 grain plated .38 Special

      What does DNR mean besides "do not resuscitate"?
    8. I

      125 grain plated .38 Special

      Looking for a recipe for 125 grain plated bullet in .38 Special . I have green dot and unique... I have to save one or the other for 9mm. Any ideas, or sources are welcome.
    9. I

      Gunsmith suggestions

      Are there any good gunsmiths in North West Indiana?
    10. I

      Rolling block.

      Who did your barrel work?
    11. I

      Rolling block.

      I always load for trapdoor pressures, and over the counter 45-70 loads should be safe in any rolling block. The bore in this is exceptionally good (for a gun builtin 1875) with deep rifling and a few small pits. I've shot side by side with a Pedersoli sharps, shared my ammo, and had nearly...
    12. I

      Rolling block.

      I'm in NW Indiana. I have a pretty good idea what it is. There are arsenal markings on it. There is an alignment mark on the barrel/receiver ... And the extractor face has two holes in it, meaning that it was converted from rimfire to center-fire. All those clues indicate that it's a 11.7x56. I...
    13. I

      Rolling block.

      I have an old rolling block rifle that is hard to find brass for. I believe it's Danish / 11.7 x 56r... I can make brass but it would be cheaper and easier to just use 45-70 brass. Is there someone who can reline just the chamber, and not the whole barrel? Any ideas are appreciated.
    14. I

      Flitz polish.

    15. I

      Flitz polish.

      Well, 3 days of soaking in mineral spirits did the trick. I also found that brakekleen works instantly . Saved my brass. And my sanity.
    See more
    Top Bottom