I have seen the conversation more than once and have even asked myself. Do you need a full length sizing die, or a small base sizing die. People have reported having issues with rounds not properly seating, getting stuck in the chamber. This is per Lee's instructions for their full length sizing die.
"Screw the full length sizer until it touches the shell holder. Then lower the ram and screw the die in 1/4 to 1/3 turn more. Raise the ram and tighten the lock ring finger tight".
There is slop in the shell holder and the ram. So you have to compensate for that. So, if you are having problems, I would first check to make sure your die is properly set up. I just loaded my first batch of .223. I followed the instructions and my brass was sized properly. I seated a bullet in a case with no primer or powder and made sure it properly chambered and extracted in my M4. I hope that this may prevent some headaches in the future for those new to reloading.
Patriot.
"Screw the full length sizer until it touches the shell holder. Then lower the ram and screw the die in 1/4 to 1/3 turn more. Raise the ram and tighten the lock ring finger tight".
There is slop in the shell holder and the ram. So you have to compensate for that. So, if you are having problems, I would first check to make sure your die is properly set up. I just loaded my first batch of .223. I followed the instructions and my brass was sized properly. I seated a bullet in a case with no primer or powder and made sure it properly chambered and extracted in my M4. I hope that this may prevent some headaches in the future for those new to reloading.
Patriot.