So I finally formed1 my seekins lower that has been sitting in the safe for over 4 years, waiting for something special...
Now my question for those who have done the same, where did you put the engraving info? Since the trigger guard is made into the reciever many places won't engrave there, the front of the magwell is out too because it is textured, I am not sure if the flairing of the magwell is not wide enough I think. So trying to keep it on the down low is a little harder, but the lower is awesome. if you can post any pics of where you did yours or an engraver who can engrave around the triggerarea with a non removable guard I would appreciate it.
Thanks!
Now my question for those who have done the same, where did you put the engraving info? Since the trigger guard is made into the reciever many places won't engrave there, the front of the magwell is out too because it is textured, I am not sure if the flairing of the magwell is not wide enough I think. So trying to keep it on the down low is a little harder, but the lower is awesome. if you can post any pics of where you did yours or an engraver who can engrave around the triggerarea with a non removable guard I would appreciate it.
Thanks!