I'm no engineer, not even close, so forgive my ignorance on the question I'm about to ask.
Would it be a bad idea in any way to use a titanium mount on the back of a stainless steel suppressor? I know titanium expands much less than stainless steel given similar temperatures so I wasn't sure if this should only be used on a titanium can.
My only concern was the steel expanding much more than the mount threads and possibly working its way off the threads easier?
I was going to use it to shave a hair more weight off the end but if this is at all a possibility I'll just buy a other stainless mount instead until I maybe wind up with a titanium can later.
Would it be a bad idea in any way to use a titanium mount on the back of a stainless steel suppressor? I know titanium expands much less than stainless steel given similar temperatures so I wasn't sure if this should only be used on a titanium can.
My only concern was the steel expanding much more than the mount threads and possibly working its way off the threads easier?
I was going to use it to shave a hair more weight off the end but if this is at all a possibility I'll just buy a other stainless mount instead until I maybe wind up with a titanium can later.