Found me a wheel gun.

[1775usmarine]

After getting the goodies researched the actual value based on bids and last buys we got $60 worth of goodies so figure around 219- 229 for the revolver.

 

[Itchytriggerfinger]

After getting the goodies researched the actual value based on bids and last buys we got $60 worth of goodies so figure around 219- 229 for the revolver.

I'll probably sell the speed loaders and holster. This sweet piece is going in a case lined with the skin of a clubbed baby seal.

 

[indiucky]

This sweet piece is going in a case lined with the skin of a clubbed baby seal.

I've got my F 150 bench seat lined in baby seal skin....Very nice...You can spill a drink and it just rolls right off of it...Good stuff but PRICEY!!!!

 

[1775usmarine]

A call to S&W CS and my 10-8 was made early 1979. My holster looks dang near brand new, but the speedloader pouch looks a bit worn along with the speedloaders.

 

[1775usmarine]

Not the greatest photos but there she finally is.

 

[Itchytriggerfinger]

She's as fine as frog fuzz. I love the engraving.

 

[Ark]

Mine is in 4473 delay jail as of today. I did get to finger it in the shop for a little while, though. I'm really impressed for $280 shipped with no sales tax.

All I need is some khakis and knee-high motorcycle boots.

 

[BehindBlueI's]

Rather than start another thread, I'm hoping some of the wheel gun crowd are still here and can tell me if this is a K frame with a square butt?

It is.

 

[Itchytriggerfinger]

Mine is in 4473 delay jail as of today. I did get to finger it in the shop for a little while, though. I'm really impressed for $280 shipped with no sales tax.

All I need is some khakis and knee-high motorcycle boots.

I hadn't considered the Poncho angle. Bravo!

 

[Snapdragon]

Pearl grips are the shizz.

My nickel-plated model 36 with dragon mother-of-pearl grips that I found on ebay. Bought the grips and then found a gun to fit them.

 

[Itchytriggerfinger]

Pearl grips are the shizz.

My nickel-plated model 36 with dragon mother-of-pearl grips that I found on ebay. Bought the grips and then found a gun to fit them.

Yes!

 

[Dead Duck]

I always wanted a Wheel Gun.

 

[Itchytriggerfinger]

Top 5. Not bad.

The 5 Best .38 Special Handguns on the Planet (Ruger and Colt Made the Cut) | The National Interest Blog

 

[Grass]

Edited the content as it was an end run around the the 50 post rule.

 

[1775usmarine]

Well I guess the excitement is over till the next smoking deal.

 

[Itchytriggerfinger]

Well I guess the excitement is over till the next smoking deal.

I'm looking! Hopefully something pops up soon because I'm ready.

 

[Snapdragon]

I would like to find a SS smith and wesson 686 4in barrel. If any one has one let me know. Thanks

I have one.

(But I'm not selling it.)

 

[SAILORGOLF46]

Picked up a former police M10-7 locally and it sure shoots to point of aim and has the typical smooth trigger of the 80's guns. What I REALLY want is a M60-10 3", hard to find but I have hope.

 

[1775usmarine]

Seen on gb they have a 10-8 with everything but speedloaders at $329 and $34 shipping. So figure $375 & up with transfer fee. Glad I got in on the ground floor. Classic firearms had the same thing minus speedloaders for $329 which also sold out.

Now I'm spying a DAO Model 64 hand pick and finger groove grips for $249 without ship plus my $10 transfer. Gotta sell another $200 worth of stuff in order to pull the trigger.

 

[Snapdragon]

My police trade-in 64 is my best-shooting wheelgun.