I am looking into getting a hollow point mold or two. I was wondering how many manufacturers there are out there. And what everybody has used. Good? Bad? Ease of use?
I know of Mihec, and NOE. I can only find information on one Lyman, wrong caliber. Are there others I should look into?
The plan is to get a .38 caliber and use it to load my .357 and 9mm. My 9mm slugs way big so I end up using .358 diameter in it and my .357. It has been working with my Lee 125gr. mold, no problems with feeding or pressure. Eventually I would like to add a .44 to the mix as well. I still need to slug that gun though.
Anybody have experience with or know of others?
I know of Mihec, and NOE. I can only find information on one Lyman, wrong caliber. Are there others I should look into?
The plan is to get a .38 caliber and use it to load my .357 and 9mm. My 9mm slugs way big so I end up using .358 diameter in it and my .357. It has been working with my Lee 125gr. mold, no problems with feeding or pressure. Eventually I would like to add a .44 to the mix as well. I still need to slug that gun though.
Anybody have experience with or know of others?