77broncoman
Plinker
Homemade wet brass tumbler setup. I made this about 2 years ago to polish a large batch of .308 brass. Heavy duty wooden frame, 1HP Grizzly motor (which is WAY oversize for the application), greasable pillow block bearings, steel roller rods with rubber over them, and homemade PVC tumbler with 10 lbs of stainless steel pins. Tumbler is currently 6" diameter and 16" long - this motor setup could accommodate the weight of a much larger tumbler if needed.
Mostly looking to sell for $300, but would be open to trade for the following (plus cash on my end if required):
* Bolt action rifles in .223 or .308
* Swiss K31 rifle
* Dillon 550 progressive reloading setup
Mostly looking to sell for $300, but would be open to trade for the following (plus cash on my end if required):
* Bolt action rifles in .223 or .308
* Swiss K31 rifle
* Dillon 550 progressive reloading setup
Last edited:
