Recent content by RMC

The #1 community for Gun Owners in Indiana

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!
    1. RMC

      Does .357 Sig Make Sense?

      If you reload then the 357 Sig isn't very costly to shoot. I think you can by once-fired brass for a reasonable price online and the projectiles are comparable to 9mm. I had a Glock 35 that I put a 357 klm barrel in and the accuracy was very impressive, especially with max loads. The 40...
    2. RMC

      Powder for Heavy 9mm reloading

      I don't like TiteGroup in 9mm only because it's harder for me to see the smaller amount of powder in the case. That's with 115 gr bullets and it would be even harder with heavier bullets. I'm having very good results with Power Pistol and it works good in the other calibers I shoot too.
    3. RMC

      Need precision shooting reload setup recommendations

      Before you toss a bunch of money into reloading equipment you should make sure your guns can shoot groups and that your optics are good enough. Loading your own ammo is fun and rewarding but your optics and the gun's capability to shoot consistently plays a higher roll in tight groups. Loading...
    4. RMC

      Difference between 223 and 22-250

      We haven't touched on the barrel twist yet. Push a 50 gr V-Max 22-250 through a 1:7-inch twist barrel and your fps will drop substantially from 3800 down to maybe 3400 fps and that is only if the jacket stays intact. The standard 22-250 barrel is 1:14-inch twist which lets you get a lot more...
    5. RMC

      Difference between 223 and 22-250

      Because when Grandma was fast she got pumped up.
    6. RMC

      Black Powder firearms discussion

      Thank you. I'll be there for sure. :-)
    7. RMC

      Black Powder firearms discussion

      What show in Noblesville?
    8. RMC

      The official "Electoral College is outdated" thread

      The United States is not a democracy and never has been. It's a republic that invokes elements of a democracy. To rely on popular vote only would essentially screw rural America. It's bad enough as it is for folks in 1-horse towns that have to pay the same Federal tax rates as the people in...
    9. RMC

      Celebrities who will leave if Trump elected President.

      I fail to see any attraction to Amy Schumer as an entertainer or a person.
    10. RMC

      So.. what are you reloading at the moment??

      22-250 50 gr Hornady V-Max, 380 90 gr Sierra V-Crown, 9mm 124 gr Hornady XTP, and 45 acp 230 gr Hornady XTP
    11. RMC

      The OFFICIAL Trump/HRC/2016 General Election Thread...

      Nobody knows if Trump will be good or not but at least we will be free of the corruption that Hillary Clinton represents. If Trump sucks we can elect him out of Office in a few years. I don't think he will do anything to warrant impeachment but if he does, he'll have to go. Hillary Clinton posed...
    12. RMC

      Light loads for 44 mag

      With many revolvers, especially Ruger Blackhawk and Redhawk series, under loading is far more dangerous than over loading. I would sooner use a 44 spl load in a 44 spl case than a 44 spl load in a 44 mag case. Load densities under 50% are too likely to dismantle your revolver.
    13. RMC

      The OFFICIAL Trump/HRC/2016 General Election Thread...

      After I voted this morning I went back home and started reflecting on all the controversies and scandals that Hillary Clinton has been involved in. Then I started thinking about the United States Constitution and just how important it is to the American way of life. After a few moments my mind...
    Top Bottom