I haven't posted any work for a while, so thought I would post some pics of the weekend project. This build is getting close and is a 2011 in .40 on a sight tracker barrel/slide that will be a USPSA limited division pistol.
Pics below of flat topping, vee design pattern, tri top, bomar cut, slide serrations and an ejector fit/install
Flattop is cut and Vee pattern that I like to use has been cut as well
Tri top has been cut now with 45deg cutter, Bomar cut in progress
Bomar profile is complete and starting to look a little better
Bomar dovetail cut, drilling/tapping for elevation screw
Setting up/cutting front serrations/scallops, rear serrations already cut
Finally found an oversize ejector (without making one) that I can get a good, tight to slide fit with minimal gaps
And...getting close to finish prep on this one
Pics below of flat topping, vee design pattern, tri top, bomar cut, slide serrations and an ejector fit/install
Flattop is cut and Vee pattern that I like to use has been cut as well
Tri top has been cut now with 45deg cutter, Bomar cut in progress
Bomar profile is complete and starting to look a little better
Bomar dovetail cut, drilling/tapping for elevation screw
Setting up/cutting front serrations/scallops, rear serrations already cut
Finally found an oversize ejector (without making one) that I can get a good, tight to slide fit with minimal gaps
And...getting close to finish prep on this one